Electrical and Instrumentation Technicians (E&I)

E&I TECHNICIAN HANDS-ON EXPERIENCE IN PLAT MAINTENANCE

 ·        E&I installation, loop testing in Oil & Gas, Chemical, petrochemical and process plant’s

·        Panels and cable installation in Manufacturing plant’s

·        Panels and cable installation in Industrial Buildings.

E&I TECHINICIAN HANDS-ON EXPERIENCE IN FIELD INSTALLATION

 ·        Electrical support installation (supports, trays and trunking)

·        Electrical Panel wiring (replace control & power cables, MCB, RCCB, RELAYS, ETC.)

·        Electrical Cable installation

·        Electrical Panel installation (Distribution boards, operation panels, control panels)

·        Electrical cable glanding & Termination

·        Electrical Testing (motors, cables, electrical equipment)

 INSTRUMENT INSTALLATION

·        Instrument installation experience (Transmitters, control valves, RTD, Thermocouples, TG, PG gauges)

·        Instrument support installation (tray & trunking, conduit pipes, flexible supports etc)

·        Instrument calibration (PT, TT, PG, LG, DPT ETC.,)

·        Instrument cable testing

·        Instrument cable glanding & termination

·        Instrument loop testing

·        Electrical & Instrument Troubleshooting

E&I TECHNICIAN HANDS-ON EXPERIENCE IN CALIBRATION AND TESTING

·        Hands-on experience in calibration of transmitters & valves (EMERSON, YOKOGAWA, E&H etc)

·        Hands-on experience in calibration of field instruments (pressure & temp, DPG gauges)

·        Experience in troubleshooting (electrical panel & control panels)

·        Good knowledge in reading SLD

·        Good knowledge in reading control wiring diagram

·        Good knowledge in understanding P&ID, instrument loop diagrams & Loop testing.

Hands-on experience in Test Equipment’s:

 - 375/475 FIELD COMMUNICATOR

• Temperature calibrator, Megger.

• Pressure calibrator RANGE:400 BAR/ RANGE:20 BAR.

• DC Regulator power supply, Earth tester, High voltage Insulation tester.

• Instrument remote sensor digital type-B FS-135,

• Digital Multifunction Tester

• FLUCK Calibrator.

• VICTOR 01 Temperature source, VICTOR 04 Voltage ma source.

• TK3 (vibration & axial displacement tester)

• FBT6 Field bus segment monitor

Requirements:

• Diploma / Higher Nitec/ Nitec in Electrical, Instrumentation Engineering or its equivalent
• 5 to 10 years of relevant work experience preferably in industrial buildings & process plants