Electronic Assembler

Use a variety of tools and equipment to assemble parts, pieces, modules, and/or components to required specifications for Navigation Aids, Surveillance Radios, and other products as required.

DUTIES & RESPONSIBILITIES

Before Assembly:

1. Ensure workstation is in proper working order (clean, well-lit, well-ventilated, tools ready, personal protective equipment is applied, etc.).
2. Review BOMs or Work Orders for each project, take inventory of parts & materials, and make determinations of acceptance/rejection for parts based on quality of workmanship.
3. Review wiring charts, diagrams, engineering assembly drawings, or other schematics to understand board layout, proper placement, and orientation, and take any needed measurements.
4. Prepare solder pot (pre-tin soldering iron, pre-tin parts as needed, etc.).

During Assembly:

1. Use a variety of hand tools, power tools, & vision magnification to:

• Complete mechanical assemblies as needed
• Cut wire and vinyl tubing to length

1. Insert component parts (such as resistors, diodes, LEDs, integrated circuits, DIP sockets, PLCC sockets, capacitors, inductors, transistors, voltage regulators, microchips, etc.) into Circuit Boards or Printed Circuit Boards (PCBs).
2. Install connectors to correct polarity and pinout specifications.
3. Operate wire crimps and inspect terminals for proper crimp.
4. Combine sheet metal, PCBs, cables, or harnesses to produce modules.
5. Assemble components and modules up to the top system or “cabinet level”, according to Institute for Printed Circuits (IPC) and Indra standards.
6. Make sure systems and sub-systems meet industry and established specifications.
7. Make any necessary corrections (remove/replace elements, remove/reapply soldering, check connections, measure battery voltage & polarity, etc.).
8. Ensure timely product delivery by adhering to deadlines per Scope of Work agreements.
9. Perform any other required job duties as assigned.

After Assembly:

1. Complete any rework as necessary when prompted by other stakeholder departments.
2. Interface with Engineering and Production departments for product reliability.
3. File Engineering Change Orders (ECOs), with supervisor approval, when needed.

QUALIFICATIONS

1. High School Diploma or equivalent (GED).
2. 18+ months of experience in Electronics Assembly.
3. Trained to IPC-A-610 or equivalent standard is desired.

REQUIREMENTS

1. Must be able to pass a U.S. government background check investigation.
2. Proof of U.S. Citizenship or U.S. Permanent Residency is a requirement for this position.
3. Lifting of heavy test equipment and systems up to 30 lbs individually.
4. Appropriate manual dexterity needed to work with a variety of hand and power tools.
5. Vision correctable to 20/20, with no color blindness or color vision deficiency.
6. May involve long periods of standing on one’s feet.
7. For successful performance of this job, an individual must be able to perform each essential duty satisfactorily. The requirements listed are representative of the general knowledge, skill, and/or ability required. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.