Engineer

Responsibilities:

• Support global NPI (New Product Introduction) on product design and development.
• Prepare drawing proposal and tooling design.
• Conduct tooling buy-off and hands-on tooling setup.
• Initiate and conduct the improvement project evaluation.
• Liaise with customer on design requirement and alignment.
• Liaise with factory on capability compliance.
• Responsible on tooling expenses and cost control.
• Overseas travelling may be required.

Requirements:

• Min. Diploma in Mechanical/ Manufacturing/ Precision Engineering.
• Proficient in using Solidworks software.
• Preferably with working knowledge and experience in taping machine, laser mark, jig & fixtures design.
• Positive attitude and self-motivated.