EQUIPMENT TECHNICIAN

ETCH EQUIPMENT TECHNICIAN

1. To achieve lowest cost of ownership of equipment

2. To establish PM and equipment improvement methodology

3. To start up new etch equipment on schedule

4. Daily machine upkeep/PM to support manufacturing objectives

5. Work as a team with both process and manufacturing engineers to meet the Module's

6. Work with manufacturing to meet the production goals

7. Troubleshoot equipment issues, establish Corrective actions and specifications for procedures to be followed.

8. Plan and implement effective Preventive Maintenance program on the equipment as well as organize Installation of new equipment.

9. Support equipment engineers' activities In Improving equipment uptime and cost reduction programs.

10. Audit and track clean swap kits availability to support wet clean.

THIN FILM TFD - EQUIPMENT TECHNICIAN

Job Responsibility:

1. To work as an Equipment Technician for wafer fabrication Chemical Vapor Deposition (CVD) equipment.
2. Perform equipment Preventive Maintenances according to maintenance schedules and procedures.
3. Troubleshoot and repair equipment failures and ensure quality recovery with minimum down time.
4. Prepare daily Preventive Maintenance, troubleshooting and repair activities reports for engineers and supervisors.
5. Maintain equipment spare parts and consumables.
6. Upkeep work area 5S housekeeping at all time.
7. Proactively initiate or participate in equipment Continuous Improvement Programs.
8. For Senior Technician and above, perform as a trainer for junior technicians.
9. For Associate Engineer or Technical Specialist, perform as Shift Leader to plan for shift maintenance activities and resources allocation.

QA TECHNICIAN

1. To execute OQA inspection and administration for outgoing wafers prior shipment.

2. To update daily outgoing wafer inspection report, maintain Etest summary, wafer map etc.

3. To ensure continuous support to daily wafer fab out and wafer quality.

4. To highlight or escalate OQA defects that exceed DPPM/WRR% or new defect.

5. Sustain SDL compliance and meet lot cycle time.

6. Maintain zero OQA escapes.

7. To support visual inspection for incoming wafers.

8. To support visual inspection for obsolete Reticles.

9. To do line troubleshooting related to OQA defects.

JOB REQUIREMENT:

1. Diploma in Mechanical/Electrical/Electronics/Mechatronics/ Chemical/ Material Science/Physics or equivalent
2. At least 2 years relevant working experience.
3. Fresh graduates with strong interest and attitude in hardware hand-on activities will be considered.
4. Must be able to work in 12 hours rotating shift (day / night / weekends / Public Holidays) in a cleanroom environment.