HVAC Engineer

• Load calculation, assessment of building characteristics, selection and equipment sizing for HVAC system.
• Preparation of Specifications, Technical Datasheets, Requisitions for Quotation, Technical queries, Technical Bid Analysis, Purchase Requisitions and Vendor Drawings / Documents review.
• Preparation of HVAC system - Ducting Layout Plan, Section & Typical details,
• Ducting line list, Ducting penetration and Connection details.
• HVAC MTO, D&ID, Airflow diagram, E3D extracted HVAC arrangement drawing, typical installation details, shop drawings and as-built drawings.
• Preparation of HVAC DRAIN - ISOMETRIC DRAWING, PIPING LAYOUT Drawing.
• Detail design using E3D modelling shall carry out following typical activities.
• Verify/Update HVAC equipment against Approved Vendor data.
• Verify/Update duct routing, accessories as per Air flow diagram.
• Perform clash check and resolve interfaces.
• Space reservation of equipment.
• Chiller/refrigerant piping routing.
• Duct/pipe supports.
• Co-ordination with other disciplines for interface engineering

Requirements

• Bachelor’s degree in engineering or related technical field.
• At least 10 - 12 years of experience in Design for Oil & Gas project.
• Software knowledge E3D, Navis works, AutoCAD, MS office, etc.
• Should have knowledge of HVAC related Codes & standards.
• Experience in basic engineering and detail design of HVAC equipment, duct routing, accessories, etc.
• Good communication skills in English (written and oral)
• Ability to work under pressure and meet project deadlines.
• Self-motivated with the ability to use own initiative.
• Ability to work independently with clarity on scope and responsibility