Part Time 2nd Shift-Production Assembly and Machine Operator

• Part-time- 4 pm- 8 pm Monday-Thursday
• Pay $17.25/ hour
• Entry Level assembly and machine operating.

Job Specifics:

• You will work with sensor insertion, bonding brushes, silver painting and copper coating.
• Read shop orders and inspect parts from various pieces of equipment to ensure compliance with established drawings and specifications.
• Work on kick press and/or punch press to install terminals on carbon brush.
• Use concave machine to place angle on carbon brush.
• Place copper wire through hole in carbon brush and secure with rivet.
• Seal wires and glue pads to carbon brush and place in oven.
• Take out of oven and clean off excess glue.
• Cut wire by specifications on shop order.
• Place copper wires through hole and secure with rivet.
• Solder brush per order specifications.
• Place sleeve (silicone cover) over wires.
• Clean/tidy your work area
• Be able to be cross trained in the department to perform different duties.
• Work with production supervisor and other department personnel in a cooperative and collaborative manner to expedite orders within the department so as to meet and exceed customer expectations in a cost-effective manner.

Job Requirements:

• Ability to successfully read and utilize inspection and measuring instruments (calipers, micrometers, protractors and ruler required).
• Requires being able to lift and/or move up to 25 pounds.
• Need to read and speak English to review Shop Order requirements required.
• High school diploma or equivalent preferred.

Job Type: Part-time

Pay: $17.25 per hour