Process Technician

·         Diploma or equivalent in Mechanical or Mechatronics Engineering

·    2–3 years’ experience in manufacturing or engineering support environment.

Training will be provided for specialized tasks (FVT, FAR, potting, fixture PM).

A. PROCESS SUPPORT RESPONSIBILITIES

• Perform product testing following approved test instructions (training provided).
• Execute FAR/dummy-run as supervised by engineers.
• Update Visual Guide and simple labelling software templates based on engineer inputs.
• Assist in FVT software download (following documented steps).
• Assist in DGS preparation for WIP failure documentation.
• Update weekly yield data for engineer review (not analysis).
• Highlight equipment abnormalities to Supervisor/Engineer — no deep troubleshooting required.
• Perform basic PM updates on jigs, fixtures, and ESD torque drivers.
• Support ESD and OSH compliance on floor.

B. MECHANICAL ENGINEERING SUPPORT RESPONSIBILITIES

·         Perform basic mechanical measurements (dimension, warpage, torque).

·         Assist in jig & fixture alignment checks and simple PM tasks (tightening, cleaning, visual check).

·         Support potting process:

o    Pre-check alignment and support

o    Basic part handling

o    Post-potting visual inspection (training provided)

·         Prepare and handle engineering samples for EVT/DVT/PVT/MLT builds with proper traceability.

·         Assist engineers in fit-up checks, connector alignment checks, and simple mechanical verification.

·         Assist in setting up mechanical validation tests (e.g., SnV fixture loading, drop test prep).

·         Document observations clearly using notes, measurements, and photos.

Able to perform simple jig/fixture setup and PM.