QA/QC ELECTRICAL ENGINEER

Ensure all electrical works comply with approved drawings, specifications, project requirements, and applicable standards (IEC, IEEE, NEC, and local codes).

Inspect and verify electrical transmission and distribution systems, including overhead lines, underground cables, substations, transformers, switchgear, and related equipment.

Review electrical drawings, method statements, Inspection and Test Plans (ITPs), and Quality Control procedures.

Conduct and witness electrical testing, inspection, and commissioning activities.

Perform insulation resistance (Megger), continuity, earth resistance, grounding, and cable testing.

Inspect and test power transformers, circuit breakers, disconnect switches, CTs, VTs/PTs, protection relays, and busbars.

Verify transmission line installation, including towers, insulators, conductors, OPGW, sagging, tensioning, clearances, and grounding.

Check cable installation, termination, jointing, phase identification, and torque tightening.

Conduct high-potential (Hi-Pot), VLF, tan delta, and other applicable cable tests according to approved procedures.

Verify relay testing, CT/VT polarity, transformer ratio, winding resistance, and circuit breaker timing/contact resistance tests.

Inspect materials and equipment upon delivery to ensure compliance with approved submittals and technical specifications.

Prepare and review inspection requests, test reports, checklists, punch lists, and non-conformance reports (NCRs).

Coordinate with clients, consultants, contractors, and commissioning teams during inspections and testing.

Ensure proper calibration and validity of electrical testing instruments.

Monitor corrective actions and verify closure of defects and non-conformities.

Ensure compliance with electrical safety procedures, LOTO, and applicable health, safety, and environmental requirements.

Prepare quality documentation, QC Inspection Reports, Test dossiers, and final handover documents.

Support pre-commissioning, commissioning, energization, and final acceptance of electrical transmission and substation systems.

Ensure all testing and inspection activities are performed by qualified personnel using approved procedures and applicable standards.