Sheetmetal Mechanic - RTP

QUALIFICATIONS:

• Able to understand all aspects of HVAC installation.
• Be dependable and able to work different areas at a time with 4-5 people in each group.
• To be able to lay-out duct for installation and look ahead to keep work going smoothly.
• Employee must have a good working attitude.
• Needs to adhere to all EAS safety policies and regulations.
• Must be capable of spotting unsafe situations and correcting them as needed.
• Has to be able to sketch fitting for duct connections. Have knowledge of signals for rigging, and setting HVAC equipment with cranes, boom trucks, lulls, and forklifts.
• Have knowledge of Welding and fabrication of supports for equipment.
• Needs to know Air flow of systems as far as—Supply; Return; Exhaust.
• Needs to be able to do Quality Control to make sure that all HVAC inline Mechanical Devices are installed according to Manufactures Instructions.
• Needs to be able to work with other Trades in a Professional manner to correct any conflicts that may arise.
• Capable of reading not only duct work drawings, but Architectural drawings to locate rooms, ceiling elevations, columns.

EDUCATION:

• Minimum of a high school education or equivalent.
• This Position requires a minimum of five (5) years of Sheet Metal experience.

JOB REQUIREMENTS/SPECIAL SKILLS:

• Requires working in conditions of varying heat and cold and where noise levels are at or above 90 decibels.
• Courses in construction safety are a requirement.
• Be able to continue job if Superintendent is not available.
• Ability to lift up to 50 lbs.