研发主任工程师-Casting

工作职责:

岗位职责：

• Leading Casting/Molding process development following the process robustness guideline for new products development to meet the product quality, yield, and manufacturability requirements

在工艺稳健开发指导文件的指导下，领导新产品的注胶/塑封工艺的开发以满足产品的质量、良率和可制造性的要求

• Leading Casting/Molding parameter study by DOE, generate/update the document like the WI, control plan and Build-sheet, responsible for training to technician/operator before handover to production

通过DOE的方法主导工艺参数的研究，生成和更新文件如WI,控制计划书，Build-sheet，在产品交接给生产之前负责培训生产的技术员和操作员

• Carry out process optimization tasks by DOE methodology. Utilize experience & knowledge for complex problem solving by why-why analysis, and provide solution with Poke-Yoke concept. Enable and support Dt-X(design to cost/test/manufactury ability)

通过DOE的方法优化工艺，利用经验和知识并使用why-why的分析方法解决复杂问题，为Poke-Yoke防错系统提供解决方案，支持和确保设计符合成本/测试/可制造性的要求

• Leading new process/equipment Technology project, improvement project when necessary

领导新工艺/新设备的开发项目，以及必要的改善项目

• Supporting the DFMEA updates, risk assessment for new product development, leading PFMEA updating

为新产品的DFMEA的更新，风险分析提供支持，主导PFMEA的更新

• Represent the Wuxi Site speaker for BAT Casting, coaching the casting/molding new engineers

代表无锡研发在BAT注胶会议上发言，辅导新加入的注胶和塑封工程师。

任职条件:

• Bachelor’s degree or master’s in electrical /Electronic Engineering /Material Science/semiconductor field

电子/电气工程，材料学专业或半导体领域的学士或硕士学位

• Above 8years working experience in LED process like casting/molding, Familiar with Protech casting machine, TOWA molding machine or other casting/molding machine model

8年以上的LED工艺如注胶或塑封经验，熟悉Protech注胶机，TOWA塑封机或其他注胶/塑封机型

• Familiar MFMEA, PFMEA, DOE, JMP or Minitab is required, Familiar with DFMEA, DFSS, QFD and Six Sigma preferred

要求熟悉MFMEA, PFMEA, DOE, JMP or Minitab软件，择优熟悉DFMEA, DFSS, QFD 和 SixSigma候选人

• CET-4 Minimum, CET-6 preferred.

候选人要求通过最低英语四级，择优考虑六级

• Can fluently use different version of office software

熟练使用不同版本的办公软件